How to Module to Module Synchronization in LabVIEW FPGA

Updated Jan 12, 2023

Reported In

Software

  • LabVIEW FPGA Module
  • LabVIEW
  • LabVIEW Real-Time Module

Issue Details

How can I synchronize between different Modules in LabVIEW FPGA?

 

Solution

To be synchronized,
  1. Use the same master timebase source
  2. Start at the same time
  3. Be read from a single FPGA I/O node. Refer to below figure.
But, there is something to be careful about.
  • Used when I/O update rates for synchronized modules must be the same.
  • The maximum sample rate should be faster than the update rate for each synchronized module.

Additional Information

If you wanted to know more about FPGA synchonization, such as chassis to chassis in LabVIEW FPGA, watch this video.

Related Links

Other Support Options

Ask the NI Community

Collaborate with other users in our discussion forums



Request Support from an Engineer

A valid service agreement or active software subscription may be required, and support options vary by country.