No I/O Server Types Available in LabVIEW

Issue Details

Solution

• This can occur if there are NI services that are not running on your computer.

1. Press Windows+R to open the Windows Run tool and enter services.msc.
2. In the Services window, make sure that the following services are running:
   • NI Configuration Manager
   • NI PSP Service Locator
   • NI Variable Engine
3. Start any of the above services that are not running. See the Additional Information section below if you are unable to start these services.
4. Completely close LabVIEW and then open it again. Try to add a new I/O server to ensure that the I/O server options are showing.

• If the steps above don't solve the issue, there might be an NI MAX Database Corruption Error. Reset the NI MAX Database following this article and then reboot the PC. Now the I/O server options should show. 
• If the project is developed on another computer, make sure you use a LabVIEW 32-bit environment to open the project. LabVIEW DSC Module does not support LabVIEW 64-bit environment.

Additional Information

• Error 1068: The dependency service or group failed to start when starting the NI Variable Engine service. This error can occur if either the NI Configuration Manager or NI PSP Service Locator is unable to start. Try manually starting these two services.
• Error 1069: The service did not start due to logon failure when starting the NI PSP Service Locator service.