Required Configuration to Run EMVco 3.0 Test Suite

Updated May 5, 2020

Reported In

Hardware

  • Micropross Accessories

Issue Details

I want to test my NFC device following EVMCo PCD Analog standard. What should I get configuration to do so?

Solution

Here is a detailed list of the configuration:

Software:

  • MPManager 3.7.2 and later version
  • EMVCo L1 contactless PICC or PCD analog
  • TCL3 firmware: Driver 1.17, FPGA 20
  • Microsoft Office Word 2007 and later version
  • setupMPRFAControl version 1.2.0 and later

External driver:
  • AD Link WD-Dask driver version 1.52
  • Picoscope 6 version 6.8.10

Hardware:
  • Platform green dongle
  • Contacless Test Station II
  • Combo CMR / LMA revision E and later
  • Flex Antenna
  • Mouse
  • Screen
  • Keyboard
  • EMVco Test Bench
  • EMco 3.0 PCD Antenna
  • EMVco 3.0 PICC 1, 2, 3.
  • Calibration Coil


Optional and highly recommended: Denso Robot with DensoRobotInterface  version 1.3.2 and later.

Additional Information

  • All those software are available for download on our Download Center

  • For existing customer with separated solution, an upgrade could be evaluated case by case. For such request, please open a Service Request the NFC & Wireless charging support team