No Value Shown When Open XNET Frame TDMS in DIAdem

Updated May 24, 2023

Reported In

Hardware

  • LIN Interface Device
  • CAN Interface Device
  • FlexRay Interface Device

Software

  • DIAdem

Driver

  • NI-XNET

Issue Details

I using CAN Input Stream to TDMS Logfile.vi LabVIEW example receiving all CAN frames and store the frames as TDMS file format. When I open TDMS in DIAdem, it don't shown any value in VIEW tab and don't pop out any error or warning. I tried checked DIAdem DataPlugin setting and it shown support TDMS file format.

How should I solve this issue?

Solution

You will need to use DIAdem Bus Log Converter to convert logfiles from CAN, LIN, and FlexRay buses into the TDM data format. 
Then, you can open the converted TDM file in DIAdem and it will shown the frame value stored.

Related Links

Other Support Options

Ask the NI Community

Collaborate with other users in our discussion forums



Request Support from an Engineer

A valid service agreement or active software subscription may be required, and support options vary by country.