Access Denied When Connecting To My Real-Time Target In LabVIEW

Updated Jul 20, 2020

Reported In

Hardware

  • cRIO-9041
  • cFP-2020

Issue Details

I am having issues trying to connect to my Real-Time target in my LabVIEW project. I am able to see the target in NI MAX and add it to a LabVIEW project. However, when I try to connect to it in LabVIEW, I get the following error: Access denied. The host computer IP address is not on the target's allowable access list.



 

Solution

This could be an issue where the software hasn't been installed correctly onto the target, or it could be that you have restricted access to only certain IP addresses when in use previously.

To resolve this issue, use the Format Disk tool in NI MAX. Check the Attempt to Restart into Safe Mode box. Select to Reset all of the networks adapters to their default settings.
 

Related Links

IP address is not on the target's allowable access list - Community Post 

Other Support Options

Ask the NI Community

Collaborate with other users in our discussion forums



Request Support from an Engineer

A valid service agreement may be required, and support options vary by country.