Error (Hex 0xBFF63167) When Deploy Project in VeriStand

Updated Oct 20, 2022

Reported In

Hardware

  • PXI FlexRay Interface Module

Software

  • VeriStand

Issue Details

I am trying to deploy a project in veristand. However, i get an error message as shown below:

NI-XNET: (Hex 0xBFF63167) There is not enough message RAM on the FlexRay hardware to configure the data partition for the object(s). Solution: Please refer to the manual for limitations on the number of objects that can be created at any given time based on the payload length.

Solution

The root cause for error 0xBFF63167 occurs is when trying to create too many objects either frames or PDUs on one interface at the same time.

The limit is only 128 objects.

Other Support Options

Ask the NI Community

Collaborate with other users in our discussion forums



Request Support from an Engineer

A valid service agreement or active software subscription may be required, and support options vary by country.