This content is not available in your preferred language.

The content is shown in another available language. Your browser may include features that can help translate the text.

sbRIO Hangs With Custom CLIP Definition Under RMC

Updated Apr 27, 2023

Reported In

Hardware

  • sbRIO-9629
  • sbRIO-9629 XC RMC Bundle

Software

  • LabVIEW Real-Time Module
  • LabVIEW FPGA Module

Issue Details

I used the sbRIO CLIP Generator to create a custom CLIP definition under the RIO Mezzanine Card for the sbRIO-9629. When I try to deploy a simple Flash LED code to the FPGA, it hangs and disconnects the board. Why is this happening? 

Solution

When creating a CLIP definition under the sbRIO's Mezzanine Card make sure that all the pins are defined as the same I/O Standard. If not all the pins are defined as the same type I/O Standard, the target will hang and disconnect. 


For example, for LVCMOS pins:
 
IOStandard.png
 
The same applies when using LVDS_25, LVTTL, or other I/O Standards.
 

Additional Information

The sbRIO CLIP Generator program will warn for incorrect pin configurations. Please pay special attention to these warnings. 

Related Links


 

Other Support Options

Ask the NI Community

Collaborate with other users in our discussion forums



Request Support from an Engineer

A valid service agreement or active software subscription may be required, and support options vary by country.

Was this information helpful?

Yes

No