LabVIEW With Vision Development Module Not Found Error When Generating Code From an Inspection

Updated Mar 15, 2018

Reported In

Software

  • LabVIEW
  • Vision Assistant
  • Vision Development Module

Issue Details

When I try to generate code from an inspection using the Vision Assistant, I receive the error shown below. How can I resolve this?

Solution

The most common cause of this error is software compatibility issues. Check the readme for the vision software you are using to check software compatibility. 

For example, if using NI Vision Development Module 2015 SP1, you can consult the NI Application Software Support section of the readme to determine that LabVIEW 2012 through 2015 are compatible with this software.

WAS THIS ARTICLE HELPFUL?

Not Helpful