Ce contenu n’est pas disponible dans votre langue préférée.

Le contenu est disponible dans une autre langue. Votre navigateur peut inclure des fonctionnalités qui vous aideront à traduire le texte.

Difference Between Differential, RSE, and NRSE Terminal Configurations

Updated Mar 28, 2024

Reported In

Software

  • Measurement & Automation Explorer (MAX)

Driver

  • NI-DAQmx

Issue Details

I am using a DAQ device to measure an analog signal. When I configure my device for the acquisition of my signal I must choose from a list of terminal configurations. What are those, and which one should I use for my application?

Solution

The tutorial How To Measure Voltage provides a good and thorough description of the different terminal configurations, and explains when to use them. For a short summary/overview continue below.   

Differential
Terminal Configuration		Referenced Single Ended (RSE)
Terminal Configuration		Non-Referenced Single Ended (NRSE) Terminal Configuration
Measures the potential difference between the AI+ and AI- Measures the potential difference between the AI and the AI GNDMeasures the potential difference between the AI and the AI SENSE


In general, it is recommended to use differential configuration when possible. Differential signal connections reduce noise pickup and avoid ground loops. The following chart summarizes ways to connect a signal source to a measurement system.

 



To find your device pinouts of your specific hardware, open NI Measurement and Automation Explorer (MAX) and follow the steps outlined in Where to Find NI-DAQmx Device Pinouts or Pin Mappings .

 

Related Links

Other Support Options

Ask the NI Community

Collaborate with other users in our discussion forums



Request Support from an Engineer

A valid service agreement may be required, and support options vary by country.