Ce contenu n’est pas disponible dans votre langue préférée.

Le contenu est disponible dans une autre langue. Votre navigateur peut inclure des fonctionnalités qui vous aideront à traduire le texte.

Error -225130 in NI-DCPower

Updated May 13, 2021

Reported In


  • Power Supply
  • PXI Programmable Power Supply


  • LabVIEW


  • NI-DCPower

Issue Details

When I run my NI-DCPower example in LabVIEW, I get error -225130 at niDCPower Initiate.vi with the following information:

Error -225130 occurred at niDCPower Initiate.vi

Possible reason(s): 
Internal Software Error occurred in Power_Supply software. Please contact National Instruments Support. 

Device: <device_name>

Component Name: nipsdk 
File Name: PowerSupply\psd\trunk\17.1\source\nipsd\primitives\dma\input\tChinchInputTransferEnginePrimitive.cpp
Line Number: 292 

unknown (0): ??? 
unknown (0): ??? 
unknown (0): ??? 
unknown (0): ??? 
unknown (0): ??? 
unknown (0): ??? 
unknown (0): ??? 
unknown (0): ??? 
unknown (0): ??? 
unknown (0): ??? 

Status Code: -225130 


Take the following steps to resolve this issue:
  1. Make sure NI-DCPower driver is installed. 
  2. Restart the controller or chassis.
  3. Move SMU/Power Supply to a different slot in the chassis.
  4. If connected through MXI, move the PCI/PCIe card to a 75W slot on the PC's motherboard.
  5. Reinstall NI-DCPower driver to fix a possible corrupt installation. 
  6. Update thunderbolt drivers if using a thunderbolt controller.
  7. Update PXI chassis firmware.
  8. Update controller BIOS.
  9. Update PC motherboard BIOS.