Adding Time-Domain To Sampled Data

Updated Feb 26, 2018

Reported In

Software

  • LabVIEW

Issue Details

I have an array of data with sampling frequency of 15 Hz, and there are 20000 points of this sampled data.  How do I convert this sampled signal to continuous time-domain ?

Solution

The following snippet shows how to read the data of multiple channels (Displace, Speed, Acceleration) from TDMS file  and convert sampled signals to have the component of time and represent them with waveform graphs. 

This will show the Build Waveform Function  being used to add the “dt” component.

Additional Information

Note : dt - This is a scalar that describes the uniform time division of the signal in seconds.

WAS THIS ARTICLE HELPFUL?

Not Helpful