Taking cRIO out of Hybrid Mode

Updated May 3, 2018

Reported In

Hardware

  • CompactRIO Controller

Software

  • LabVIEW FPGA Module

Issue Details

I have my cRIO in Hybrid Mode. I would like to interact with it normally in FPGA mode or Scan interface mode only. 

Solution

  1. Open your project
  2. Add a new unconfigured target with the same type of cRIO. 
  3. Copy all of the files from the existing cRIO to the new unconfigured cRIO.
  4. Delete the old target (make note of the IP Address)
  5. Configure the new target to connect with the same IP Address. Right click the target and set the IP in "Properties" 

WAS THIS ARTICLE HELPFUL?

Not Helpful