Crash Reporter Error After Closing Vision Builder for Automated Inspection

Updated Apr 16, 2018

Reported In

Software

  • Vision Builder for Automated Inspection

Issue Details

I am running 4 similar Vision Builder for Automated Inspection (VBAI) inspections simultaneously. Upon closing either of the inspection, the Vision Builder Crash Reporter will always show. However, if I run only 1 Inspection at a time, this Vision Builder Crash Reporter will not show.

Error message:
We apologize for the inconvenience
Vision Builder 6.1.0.0 encountered a problem and needs to close.

Exception: Access violation (0xC0000005) at EIP=0x00000000319F1F77
Version:6.1.0.0
A local copy of the error report was saved in this location: LabVIEW Data Folder

View Report Report ID: 5d20e08b-696e-42f1-a3b5-5dec9fcb2b1f

 

Solution

To remove this, run the inspections in Inspection Mode instead of Configure Mode

WAS THIS ARTICLE HELPFUL?

Not Helpful