This content is not available in your preferred language.

The content is shown in another available language. Your browser may include features that can help translate the text.

Connecting an Encoder to a Counter

Updated Oct 22, 2019

Reported In

Other

Counter/Timers (TIO)

Issue Details

I want to measure frequency, period, pulse width, semi period, two edge separation, position, velocity, duty cycle, or count edges with my NI hardware. How do I wire up or connect my encoder to a counter?

Solution

The encoder has five outputs: Channel A Out, Channel B Out, Channel A Inverse Out, Channel B Inverse Out and Z-Index.

Connecting the encoder to a single counter:
  1. Choose Channel A and Channel B or Channel A Inverse and Channel B Inverse. Do not connect a non-inversed and an inversed channel to the same counter. For example, Channel A Out and Channel A Inverse Out should not be connected to the same counter.
  2. After selecting a valid pair of inversed or non-inversed channels, make one of the following connections configurations depending on the channel pair selected:
    • Configuration 1
      • Channel A to Source
      • Channel B to AUX
      • Z-Index to Gate
    • Configuration 2
      • Channel A Inverse to Source
      • Channel B Inverse to AUX
      • Z-Index to Gate

An easy way to find the pin connections to these counters is to right click the device in Measurement & Automation Explorer (MAX) and select Device Pinout.

Connecting the encoder to two counters:
In some critical applications, a single encoder is connected to two counters to keep track of precise counting. To do this, make the following connections:
  1. Connect the non-inversed pair of channels and the Z-Index to Counter 1 in Configuration 1 above.
  2. Connect the inversed pair of channels and the Z-Index to Counter 2 in Configuration 2 above. The Z-Index is connected to both counters.

Additional Information

Some encoders require a pull-up resistor to work properly with a DAQ device. Review the specification sheet for the cDAQ and the encoder to confirm if the resistor is needed and the value of it.

WAS THIS ARTICLE HELPFUL?

Not Helpful