How to Connect NI 9219 and DMM Using Calibration Executive

Updated Jun 26, 2018

Reported In

Hardware

  • NI-9219

Software

  • Calibration Executive

Issue Details

I am using NI Calibration Executive to calibrate my NI 9219 C series module.

The calibration procedure in Calibration Executive help lists two DMMs as required test equipment but I cannot find any schematic showing how to connect the 9219 module to the DMMs.
 

Solution

You can refer to the detailed NI 9219 Calibration Procedure manual to find the connection schematics for the different Verification procedures.

For example, on page 6 of the Calibration Procedure manual, you can find the Voltage Accuracy Verification Connections to the NI 9219, as follows:
 

 

WAS THIS ARTICLE HELPFUL?

Not Helpful